dating Katy, Texas ladies
Chat now


  • Years old:
  • 32
  • Nationality:
  • Latvian
  • My sexual identity:
  • I like man
  • Color of my eyes:
  • Enormous blue eyes
  • My gender:
  • Fem
  • Sign of the zodiac:
  • Libra
  • What is my figure features:
  • My body features is chubby
  • What is my hobbies:
  • I like learning foreign languages


Simply unscrew the existing jack from the wall, and attach the color-coded wires for the new cable to the matching terminals. I tried the above method of running a cable from an existing jack to a room that has no jack but my internet failed. My intent is to have the existing jack still function work while I run a wire to a room that has no jack.


This application note will attempt to take any novice through the process.

Country Club Estates, Georgia, 31525 penpals free

Or at least give you some pointers that will help. A phone line uses two conductors. Typical old-style telephone cable has four conductors.

How to install a dsl line

Red, Green, Black, and Yellow or White. The first phone line will be on the Red and Green wires. The black and yellow wires will be unused and may not even be connected.

yorkies for free in Crab Orchard, West Virginia, 25801 25827

If you connect them right, you can use the black and yellow wires to carry the new line from the outside of the house to the desired wall-jack s. Standard modular wall-jacks can support both these lines. And you can use either a two-line phone or a plug-in two line splitter to get to the second line. Note: Sharing two phone lines in non-twisted "quad" telephone cable will probably introduce some crosstalk. You may be able to hear whatever is going on the other line at a very low level. There isn't anything you can do about this except rewire all your phones with more current twisted-pair wire.

The first step is to perform a bit of what we call "Telephonic Archeology" by examining your present wiring to try to determine what goes where. Go around the house with a small straight screwdriver and "pull" all the phone jacks.

east Vernal, Utah, 84078 84079 dating

For surface mount boxes, remove the single screw and gently pull the cover away. For jacks that are built-in to the wall, remove the two visible screws and gently pull the wall plate away from the wall until you can see how the wires are connected behind the plate.

romantic date ideas in Jacksonville, Alabama, 36265

If you are being watched, stare intently at all these wires, rub your chin, and nod knowingly this is very important. You may do this for an extended period if you wish. You will most likely see one cable going to the jack, either from inside the wall, or stapled to the surface of the wall. This cable will probably have four solid conductor wires in it; one red, one green, one black, and one yellow or white. If the wire doesn't have four conductors, you have a non-standard installation and you'll need help.

How to install telephone wiring myself

This cable either goes straight to the DMARC block more on this later or it connects to the back of another jack If there is more than one cable, and the wires from one cable are tied to the same color wires from the other cable, especially the red and green then you are looking at a "daisy-chain" jack.

It doesn't really matter at this point. Each jack should have 2 or 4 screw terminals. They may be labeled with the wire color: R red G green Y yellow B black. The jacks will also have 2 or 4 individual wires that run from the modular jack to the screw terminals. The main thing you're trying to determine at this point is whether all jacks have all four wires, and if they are connected.

Leave the jacks loose, you may need to work on them later.

chat free Hartford, CT

An explanation: The phone company has this concept of a "point of demarcation" where they are completely responsible for the phone lines to a certain point This point is usually on an outside wall of a house, or possibly just inside a garage. Usually they are a little gray box with something about the phone company written on them and may have some rather large wires going into them.

Doing your own telephone wiring

But they could also have replace your existing box with a new version that supports two or more lines, or they may have added a second DMARC box for the new line. It's up to them which they do. There will be two or more screw terminals inside. Note the cables that come from the house and which wires connect to which terminals.

We'll figure these out later. Probably the easiest thing to do is to connect the new phone line to all or most jacks. This new line will be "line 2" in your jacks.

What is the basic telephone wiring setup in the home?

Any 2-line phone plugged into these jacks will allow access to the second line. If it's a fax or modem line, you may need to only to go to a certain jack. To do this, you'll need to get the black and yellow or white wires hooked up in the jack, and figure out where the cable goes and which cable it is back at the DMARC box. Just hook up the wires to the new line more later.

Now it's time to actually do something. You'll need a bit of test equipment:. What you have done is build home-brew versions of sophisticated test equipment. If you plan on making a career out of this, you can buy the real thing. Inside this box, you should see some green and red wires going to two screw terminals.

If you connect one wire from your improvised "butt-set" to each of these screw terminal, you should get a dial-tone when you pick up the phone. To test to see if you have the "correct" line, dial the .

post free classified ads in Providence, Rhode Island

Make sure nobody is using the phone inside. If you get a busy al, you are probably on that line. This method isn't fool-proof, but the special the phone repairmen use is apparently an industry secret, to which we mere mortals are not to be trusted. If there is a modular plug and jack near these terminals, this is your "test port. The phone company will tell you to do this to test the line before they come out to fix anything.

Santa Ana, CA girls looking for sex

It proves that the problem is either on your side of the wiring or their side. If you don't have a modular plug and jack, don't worry, you don't need them for this exercise.

Telephone line

Determine which cable feeds which jack s inside your home. You may not need to do this if you are going to feed the new line to all jacks.

meet Radcliff, Kentucky women

Plug the standard modular cable into the telephone. Disconnect one green wire from the screw terminal. Now run around the house plugging in your telephone to see if you have a dial-tone at each jack. The jack s that stopped working are connected to the wire you just disconnected.

Reconnect the green wire. Disconnect another green wire You may find that some cables don't appear to go anywhere.

Can i hook up a phone & fax at the same time?

That's not unusual in an older home. They may be color coded black and yellow, or a second set of green and red, or have B and R labels, or simply be two more "posts" opposite the ones in use. Connect to terminals until you get a dial-tone and call the new to make sure you get a busy al.

man seeking man in Mineola, New York

You can also go inside and call the new to see if the test phone rings. When you identify these terminals, connect the black and yellow or white wires of the jack s where you want the new line. You're almost done. The only thing left is to make sure the black and yellow wires are carried all the way through and are connected in the target jack.

Plug your test phone into Line 2 of the two-line adapter and plug the adapter into the target jack. If you get a dial-tone If not, go around to any other jacks that are on that cable and make sure that the black and yellow wires are "passed on," either by splicing the two blacks together and the two yellows together, or by connecting both blacks to the B terminal and both yellows to the Y terminal in the jack.

How to add a phone extension

If you want all jacks to have the new line. Just make sure that all the jacks have the black and yellow wire connected. If you ever have phone trouble in the future Log in Username:. Password: CapsLock is on. Remember me for 1 week.

Log in. I forgot my password Register. Comments 1. Newest Blog Posts. A new home. We had the phone company install a second phone line, which we're going to use for our modem. So now they say the line is "installed.

Recent users


Only a few basic tools are needed, and the parts are available at home-improvement stores.


Return to Telephone Troubleshooting articles.


Connecting your fax machine and your telephone requires an active telephone line.


Limited Warranty.